Suzuki SWIFT RS415 2017, Service Manual

Page: 351 / 1257

Engine Cooling System: 1F-12
3) Install water pump pulley.
4) Install water pump / generator drive belt referring to
“Water Pump / Generator Drive Belt Removal and
Installation: ”.
5) Install A/C compressor belt (if equipped) referring to
“Compressor Drive Belt Removal and Installation: in
Section 7B”.
6) Refill cooling system referring to Step 7) to 22) of
“Cooling System Flush and Refill: ”.
7) Connect negative cable at battery.
8) Check each part for leakage.
Water Pump Inspection
S4RS0A1606018
CAUTION:
Do not disassemble water pump.
If any repair is required on pump, replace it
as assembly.
Rotate water pump by hand to check for smooth
operation. If pump does not rotate smoothly or makes
abnormal noise, replace it.
Specifications
Tightening Torque Specifications
S4RS0A1607001
NOTE:
The specified tightening torque is also described in the following.
“Cooling System Components: ”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Fasteners Information: in Section 0A”.
Special Tools and Equipment
Recommended Service Material
S4RS0A1608001
I2RH0B160018-
I2RH0B160019-
Fastening part
Tightening torque
Note
N
˜
m kg-m lb-ft
Air ventilation bolt 4.5 0.45 3.5
)
/
)
Generator adjusting bolt 23 2.3 17.0
)
Generator pivot bolt 50 5.0 36.0
)
Water pump bolt and nut 25 2.5 18.0
)
Material SUZUKI recommended product or Specification Note
Water tight sealant SUZUKI Bond No.1207F P/No.: 99000–31250 )