Suzuki SWIFT RS415 2017, Service Manual

Page: 757 / 1257

Clutch: 5C-11
5) Install tap (M16 X 1.5) (1) to clutch release shaft
No.1 bush.
6) Pull No.1 bush out using tap (1) and special tools.
Special tool
(B): 09923–46020
(C): 09930-30104
Installation
1) Drive in a new No.1 bush using special tools and
hammer, and then apply grease to bush inside.
Special tool
(A): 09943-88211
(B): 09923-46030
“A”: Grease 99000–25010
2) Install release shaft.
3) Apply grease to No.2 bush (1) inside and press-fit it
using the same special tool as in removal.
“A”: Grease 99000–25010
Special tool
(A): 09922-46010
4) Coat grease to release shaft seal (2) lip and then
install it till it is flush with case surface. Use special
tool for this installation and face seal lip downward
(inside).
“A”: Grease 99000–25010
Special tool
(B): 09925-98221
5) Caulk seal at A using caulking tool and hammer.
6) Apply grease to release bearing inside and release
shaft (2), then set release bearing (1).
“A”: Grease 99000–25010
7) Apply small amount of grease to input shaft (3)
spline (0.3 g (0.01 oz)) and front end (0.15 g (0.005
oz)) as well.
“B”: Grease 99000–25210
IYSY01531016-
IYSY01531017-
I3RM0A530016-
I3RM0A530017-