Suzuki SWIFT RS415 2017, Service Manual

Page: 498 / 1257

4C-7 Rear Brakes:
Installation
1) Install brake back plate (1) and spindle (2), and
tighten spindle bolts (3) by hand.
2) Install rear wheel speed sensor (1) to brake back
plate (2).
Tightening torque
Rear wheel speed sensor bolt (a): 11 N·m (1.1
kg-m, 8.0 lb-ft)
3) Tighten spindle bolts (b) to specified torque.
Tightening torque
Spindle bolt (b): 73 N·m (7.3 kg-m, 53.0 lb-ft)
4) Install parking brake cable (1) to brake back plate
Tightening torque
Parking cable cap nut (a): 10 N·m (1.0 kg-m, 7.5
lb-ft)
5) Install wheel cylinder and connect brake pipe flare
nut, and then tighten wheel cylinder bolts and flare
nut to specified torque referring to “Wheel Cylinder
Removal and Installation: ”.
6) Install brake shoe referring to “Rear Brake Shoe
Removal and Installation: ”.
7) Install brake drum referring to step 2) to 7) of “Rear
Brake Drum Removal and Installation: ”.
8) Fill reservoir with brake fluid and bleed brake
system. For bleeding operation refer to “Air Bleeding
of Brake System: in Section 4A”.
9) Upon completion of all jobs, depress brake pedal
with about 300 N (30 kg, 66 lbs) load 3 to 5 times so
as to obtain proper drum-to-shoe clearance.
Adjust parking brake cable.
Tightening torque
Wheel nut (a): 85 N·m (8.5 kg-m, 61.5 lb-ft)
10) Check to ensure that brake drum is free from
dragging and proper braking is obtained. Then
remove vehicle from hoist and perform brake test
(foot brake and parking brake).
11) Check each installed part for fluid leakage.
1
2
3
I4RS0A430022-
(a)
(b)
2
1
I4RS0A430023-
1
(a)
I4RS0A430024-