Suzuki SWIFT RS415 2017, Service Manual

Page: 415 / 1257

Front Suspension: 2B-5
NOTE:
When servicing component parts of strut
assembly, remove strut rod cap and then
loosen strut nut a little before removing strut
assembly. This will make service work easier.
Note, however, nut must not be removed at
this point.
2) Hoist vehicle, allowing front suspension to hang free.
3) Remove wheel and disconnect stabilizer joint (1)
from strut bracket.
When loosening joint nut, hold stud with special
tools.
Special tool
(A): 09900–00411 (socket)
(B): 09900–00413 (5 mm)
4) Remove brake hose mounting bolt (1) and take off
brake hose (2) and then ABS wheel speed sensor
harness (3) (if equipped) from strut bracket as shown
in figure.
5) Remove strut bracket bolts and nuts (4).
6) Remove strut rod cap.
7) Remove strut nut (1), and remove rebound stopper
(2).
NOTE:
Hold strut by hand so that it will not fall off.
8) Remove strut assembly.
Installation
Install strut assembly by reversing removal procedure,
noting the following instructions.
• Insert bolts in such direction as shown in figure.
• Tighten all fasteners to specified torque.
Tightening torque
Strut bracket nut (a): 105 N·m (10.5 kg-m, 76.0 lb-
ft)
Brake hose mounting bolt (c): 25 N·m (2.5 kg-m,
18.0 lb-ft)
Stabilizer joint nut (d): 50 N·m (5.0 kg-m, 36.5 lb-
ft)
• Lower hoist and vehicle in non-loaded condition,
tighten strut nut (b) to specified torque.
Tightening torque
Strut nut (b): 50 N·m (5.0 kg-m, 36.5 lb-ft)
CAUTION:
• Don twist brake hose and ABS wheel
speed sensor harness (if equipped) when
installing it.
• Install ABS wheel speed sensor harness (if
equipped) to strut bracket as shown in
figure.
1
(A)
(B)
I4RS0A220004-
1
3
2
2
1
4
4
3
I4RS0A220005-
2
1
I4RS0A220006-