Suzuki SWIFT RS415 2017, Service Manual

Page: 952 / 1257

8B-82 Air Bag System:
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear DTCs referring to “DTC Clearance: ”, if any.
• Repeat “Air Bag Diagnostic System Check: ” to confirm that the trouble has been corrected.
DTC B1064 / B1068: Driver / Passenger Side-Air Bag Initiator Circuit Short to Power Circuit
S4RS0A8204075
Wiring Diagram
CAUTION:
• Be sure to perform “Air Bag Diagnostic System Check: ” before starting diagnosis according to
flow.
• When measurement of resistance or voltage is required in this flow, use a tester along with a correct
terminal adapter from special tool (Connector test adapter kit).
• When a check for proper connection is required, refer to “Inspection of Intermittent and Poor
Connections: ”.
• If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.
DTC Will Set when
The voltage measured at side-air bag (driver or passenger) initiator circuit is above a specified value for specified time.
Flow Test Description
Step 1:
Check whether malfunction is in side-air bag (inflator) module.
Step 2: Check side-air bag initiator circuit in floor harness.
Step 3: Check side-air bag initiator circuit in seat harness.
1
2
3
GRN
RED
8
BLK
L29-26
L29-27
IG
E1
4
“L29”
“L04”
“G32”
“L29”
L29-11
DS+
L29-10 DS-
WHT/GRN
WHT/RED
5
6
“L25”
L29-12 PS+
L29-13 PS-
LT GRN/RED
GRY/BLU
7
“L30”
[A]
I4RS0A820031-
[A]: Shorting bar 3. “A/BAG” fuse 6. Driver side-air bag (inflator) module
1. From main fuse 4. Junction block assembly 7. Passenger side-air bag (inflator) module
2. Ignition switch 5. SDM 8. Ground for air bag system