Suzuki SWIFT RS415 2017, Service Manual

Page: 1118 / 1257

9C-11 Instrumentation / Driver Info. / Horn:
Ignition Switch Inspection
S4RS0A9306002
• Check for continuity between terminals at each switch
position. If check result is not as specified, replace
switch.
Combination Meter Removal and Installation
S4RS0A9306003
Removal
1) Disconnect negative (–) cable at battery.
2) Remove column hole cover (1) pulling it in arrow
direction shown in figure.
3) Remove combination meter cluster panel (1) pulling
it in arrow direction shown in figure.
4) Remove screws (1) fastening combination meter.
5) Remove combination meter (2) pulling it arrow
direction as shown.
Installation
Reverse removal procedure.
Fuel Level Sensor Removal and Installation
S4RS0A9306004
Removal
Remove fuel pump assembly referring to “Fuel Pump
Assembly Removal and Installation: in Section 1G”.
Installation
Install fuel pump assembly referring to “Fuel Pump
Assembly Removal and Installation: in Section 1G”.
Fuel Level Sensor Inspection
S4RS0A9306005
• Check that resistance between terminals “a” and “b”
of fuel level sensor changes with change of float
position.
• Check resistance between terminals “a” and “b” at
each float position in the following.
If the measured value is out of specification, replace
fuel pump.
Fuel level sensor specifications
Position
Terminal
LOCK
ACC
ON
START
OFF
ON
K2 K1 ST IG2 IG1 ACC B1 B2
Key
ST IG2
IG1
ACC
B1
B2
K2
K1
I4RS0A930009-
1
I4RS0A930010-
Float Position Resistance (
:
)
Full Upper “c”
31.0 mm
(1.22 in.)
40
r
2
Full Lower “d”
172.0 mm
(6.77 in.)
280
r
3
1
I4RS0A930011-
1
2
I4RS0A930012-