Suzuki SWIFT RS415 2017, Service Manual

Page: 476 / 1257

4A-9 Brake Control System and Diagnosis:
• Perform brake test and check installed part for fluid
leakage.
Rear Brake Hose / Pipe Removal and
Installation
S4RS0A4106008
Removal
1) Raise and support vehicle properly. Remove tire and
wheel.
2) Clean dirt and foreign material from both flexible
hose end and pipe end fittings.
3) Remove brake flexible hose or pipe.
Installation
Reverse brake flexible hose installation procedure,
noting the following.
• Fill and maintain brake fluid level in reservoir.
• Bleed brake system. Refer to “Air Bleeding of Brake
System: ”.
• Perform brake test and check each installed part for
fluid leakage.
• Never reuse protector nut once removed. Be sure to
use a new one.
• Install clamps properly referring to the figure and
tighten bolts.
• When installing hose, make sure that it has no twist or
kink.
Brake Hose and Pipe Inspection
S4RS0A4106009
Hose
The brake hose assembly should be checked for road
hazard damage, for cracks and chafing of outer cover,
for leaks and blisters. A light and mirror may be needed
for an adequate inspection. If any conditions are
observed on brake hose, it is necessary to replace it.
Pipe
Inspect the pipe for damage, cracks, dents and
corrosion. If any defect is found, replace it.
Master Cylinder Components
S4RS0A4106010
I2RH01410012-
I4RS0A410025-