Suzuki SWIFT RS415 2017, Service Manual

Page: 282 / 1257

1D-19 Engine Mechanical:
28) Lower engine with transaxle from engine
compartment.
CAUTION:
Before lowering engine, to avoid damage to
A/C compressor and clutch operating
cylinder, make clearance by rising them. Be
sure not to damage suspended A/C
compressor and clutch operating cylinder.
29) Disconnect transaxle from engine, referring to
“Manual Transaxle Unit Dismounting and
Remounting: in Section 5B” or “Automatic Transaxle
Unit Dismounting and Remounting: in Section 5A”.
30) Remove clutch cover and clutch disk referring to
“Clutch Cover, Clutch Disc and Flywheel Removal
and Installation: in Section 5C”.
Installation
1) Install clutch cover and clutch disk referring to
“Clutch Cover, Clutch Disc and Flywheel Removal
and Installation: in Section 5C”.
2) Connect transaxle to engine referring to “Manual
Transaxle Unit Dismounting and Remounting: in
Section 5B” or “Automatic Transaxle Unit
Dismounting and Remounting: in Section 5A”.
3) Lift engine and transaxle into engine compartment
with jack.
4) Install engine left mounting bracket nuts (1) and
engine right mounting nuts (2).
Tighten these nuts to specified torque.
Tightening torque
Engine left mounting bracket nut (a): 55 N·m (
5.5 kg-m, 40.0 lb-ft)
Engine right mounting nut (b): 65 N·m (6.5 kg-
m, 47.0 lb-ft)
5) Support engine assemble by using supporting
device referring to “Engine Supporting Points: in
Section 0A”.
6) Install engine rear mounting to engine rear mounting
No.1 bracket.
Tightening torque
Engine rear mounting bush bolt: 55 N·m (5.5 kg-
m, 40.0 lb-ft)
7) Install suspension frame referring to “Front
Suspension Frame, Stabilizer Bar and/or Bushings
Removal and Installation: in Section 2B”.
8) Remove supporting device.
9) Install exhaust No.1, No.2 and center pipes referring
to “Exhaust Pipe and Muffler Removal and
Installation: in Section 1K”.
10) Connect drive shaft joints referring to “Front Drive
Shaft Assembly Removal and Installation: in Section
3A”.
11) Reverse disconnected hoses, cables and electric
wires for connection noting the followings.
• Tighten nuts to specified torque.
Tightening torque
Starting motor terminal nut: 11 N·m (1.1 kg-m,
8.0 lb-ft)
Generator terminal nut: 6 N·m (0.6 kg-m, 4.5 lb-
ft)
12) Install air cleaner case and resonator.
13) Install cowl top referring to “Cowl Top Components:
in Section 9K”.
14) Install A/C compressor to its bracket (if equipped)
referring to “Compressor Assembly Removal and
Installation: in Section 7B”.
I4RS0A140009-
1, (a)
2, (b)
I4RS0A140010-