Suzuki SWIFT RS415 2017, Service Manual

Page: 496 / 1257

4C-5 Rear Brakes:
5) Remove push nut (1).
6) Remove parking brake shoe lever (2) from shoe rim
(3).
Installation
Install parts in reverse order of removal, noting the
following.
• Install shoe hold down springs (1) by pushing them
down in place and turning hold down pins (2).
• Install brake drum referring to step 2) to 10) of “Rear
Brake Drum Removal and Installation: ”.
Rear Brake Shoe Inspection
S4RS0A4306005
• Check ratchet of brake strut (1) assembly for wear or
damage.
• Check shoe return spring, antirattle spring and shoe
hold down spring for damage, corrosion and
weakening.
• Check for smooth movement of brake shoe lever (2)
along shoe rim.
If any defective or malfunction is found, repair or replace.
Wheel Cylinder Removal and Installation
S4RS0A4306006
Removal
1) Remove brake drum referring to “Rear Brake Drum
Removal and Installation: ”.
2) Remove brake shoe referring to “Rear Brake Shoe
Removal and Installation: ”.
3) Loosen brake pipe flare nut (1) but only within the
extent that fluid does not leak.
4) Remove wheel cylinder mounting bolts. Disconnect
brake pipe from wheel cylinder and put bleeder plug
cap (1) onto pipe to prevent fluid from spilling.
Installation
1) Take off bleeder plug cap from brake pipe and
connect pipe to wheel cylinder (1) just enough to
prevent fluid from leaking.
2) Install wheel cylinder (1) to brake back plate (2), and
tighten wheel cylinder mounting bolts to specified
torque.
Tightening torque
Wheel cylinder mounting bolt (a): 12 N·m (1.2
kg-m, 9.0 lb-ft)
3) Tighten flare nut of brake pipe (3) to specified torque.
Tightening torque
Rear brake pipe flare nut (b): 16 N·m (1.6 kg-m,
11.5 lb-ft)
1
2
3
I4RS0A430014-
2
1
I4RS0A430012-
I4RS0A430016-
1
I4RS0A430015-
1
I4RS0A430017-