Suzuki SWIFT RS415 2017, Service Manual

Page: 1119 / 1257

Instrumentation / Driver Info. / Horn: 9C-12
Oil Pressure Switch Removal and Installation
S4RS0A9306006
For removal and installation, refer to “Oil Pressure
Check: in Section 1E”.
Oil Pressure Switch Inspection
S4RS0A9306007
1) Disconnect oil pressure switch (1) lead wire.
2) Check for continuity between oil pressure switch
terminal (2) and cylinder block (3) as shown.
If check result is not as specified, replace oil
pressure switch (1).
Oil pressure sensor specification
During engine running: No continuity
At engine stop: Continuity
VSS Removal and Installation
S4RS0A9306008
For removal and installation, refer to “Vehicle Speed
Sensor (VSS) Removal and Installation: in Section 5B”
or “Output Shaft Speed Sensor (VSS) Removal and
Installation: in Section 5A”.
VSS Inspection
S4RS0A9306009
Refer to “Vehicle Speed Sensor (VSS) Inspection (M/T
model): in Section 1C” or “Output Shaft Speed Sensor
(VSS) Inspection: in Section 5A”.
Engine Coolant Temperature (ECT) Sensor
Inspection
S4RS0A9306010
Check engine coolant temperature sensor for resistance,
refer to “Engine Coolant Temperature (ECT) Sensor
Inspection: in Section 1C”.
Brake Fluid Level Switch Inspection
S4RS0A9306011
Check for continuity between terminals of brake fluid
level switch coupler (1). If found defective, replace
switch.
Brake fluid level switch specification
OFF position (float up): No continuity
ON position (float down): Continuity
1. Fuel pump
2. Float
4. Engine oil filter F: Front
“a”
“b” 1
“c”
“d”
2
2
I4RH01930003-
I3RM0A930009-
1
I4RS0A930013-