Immobilizer Control System: 10C-1
Immobilizer Control System
Precautions
Precautions in Diagnosing Troubles
S4RS0AA300001
• Before confirming the diagnostic trouble code (DTC),
do not disconnect connector from ECM, battery cable
from battery, ground wire harness, or main fuse. Such
disconnection will erase DTC stored in ECM.
• DTC stored in ECM memory can be checked as well
as cleared by using SUZUKI scan tool. Before using
SUZUKI scan tool, read its operator’s manual
carefully to know how to use it and what functions are
available.
• Be sure to read “Precautions for Electrical Circuit
Service: in Section 00” before inspection.
• Communication of ECM, BCM, and combination
meter is established by CAN (Computer Area
Network). Therefore, handle CAN communication
lines with care referring to “Precaution for CAN
Communication System: in Section 00”.
Precaution in Replacing ECM
S4RS0AA300003
After ECM is replaced with new one, the transponder
code in the transponder built in the ignition key has to be
registered with ECM. Or, the engine cannot be started
up. For the registration procedure, refer to “Procedure
after ECM Replacement: ”.
Precautions in Handling Immobilizer Control
System
S4RS0AA300002
• Do not turn ON ignition switch with ignition key in
contact with another one or quite close to another
one. Or, the immobilizer control system may detect
some abnormal condition and prevent the engine from
starting.
• Do not turn ON ignition switch by using ignition key
with any type of metal (1) wrapped its grip or in
contact with it. Or, the immobilizer control system may
detect some abnormal condition and prevent the
engine from starting.
• Do not leave ignition key in a place where
temperature is high. High temperature may cause
damage to the transponder built in the ignition key.
• Do not turn ignition switch to ON position by bringing
radio antenna close to coil antenna. Or, the
immobilizer control system may detect some
abnormal condition and prevent the engine from
starting.
I3RH0AA30001-
1
I3RH0AA30002-
I3RH0AA30003-
I3RH0AA30004-
Summary of Contents for SWIFT RS415 2017
