Suzuki SWIFT RS415 2017, Service Manual

Page: 1104 / 1257

9B-9 Lighting Systems:
Stop (Brake) Lamp Switch Inspection
S4RS0A9206011
Check stop (brake) lamp switch for continuity between
terminals at each switch position.
If check result is not as specified, replace switch.
Turn Signal Light Switch (in Lighting Switch)
Removal and Installation
S4RS0A9206012
For removal and Installation, refer to “Headlight Switch
(in Lighting Switch) Removal and Installation: ”.
Turn Signal Light Switch (in Lighting Switch)
Inspection
S4RS0A9206013
Check for continuity between terminals at each switch
position. If check result is not as specified, replace
switch.
Turn Signal and Hazard Warning Relay Removal
and Installation
S4RS0A9206020
Removal
1) Disconnect negative (–) cable at battery.
2) Remove junction block assembly referring to “BCM
(Included in Junction Block Assembly) Removal and
Installation: in Section 10B”.
3) Remove turn signal and hazard warning relay.
Installation
Reverse removal procedure for installation.
Turn Signal and Hazard Warning Relay
Inspection
S4RS0A9206021
1) Connect turn signal and hazard warning relay (1),
battery (2) and six test bulbs ((12V, 21W) (3) and 12
V, 5W (4)) as shown.
2) Check turn L circuit
Connect terminal “5” and battery negative (–)
terminal by a jumper wire.
Check left side bulbs (1) for flashing cycle.
If check result is not as specified, replace turn signal
and hazard warning relay.
Reference flashing cycle
60 – 120 cycle/minute
4
2
3
1
Terminal
Shaft condition
FREE
PUSH
1 2 3 4
I4RS0A920012-
L
R
Terminal
Turn signal SW
3 1 2
L
N
R
1 2 3
I4RS0A920013-
2
4
3 3
3
8 7
1 2
6 5 4
1
I4RS0A920014-
1
3
8 7
1 2
6 5 4
I4RS0A920015-