Suzuki SWIFT RS415 2017, Service Manual

Page: 1145 / 1257

Glass / Windows / Mirrors: 9E-11
Installation
Reverse removal procedure noting the following.
• Apply grease to sliding and rotating portions of
window regulator.
: Grease 99000–25010
• Tighten rear door window regulator attaching screws.
Rear door window regulator screw tightening
order
(a)
o
(b)
Rear Door Window Regulator Inspection
S4RS0A9506010
Check the following point:
• Check regulator sliding and rotating parts.
• Check rollers for wear and damage.
Rear End Door Window Components
S4RS0A9506012
Rear End Door Glass Removal and Installation
S4RS0A9506013
Refer to “Windshield Removal and Installation: ” as
removal and installation procedures are basically the
same. However, note the following.
• Observe the following precautions when applying
adhesive (1) along glass (2) edge.
• Adhesive (1) should be applied evenly especially in
height.
• Be careful not to damage primer (3).
• With the position of fastener (4) properly aligned,
install glass (2) on rear end door panel (5).
• Press glass against body quickly after adhesive (1) is
applied.
Adhesive amount specifications and position for
rear end door glass
Height “a”: 13 mm (0.51 in.)
Width “b”: 6 mm (0.24 in.)
Width “c”: 14 mm (0.55 in.)
Position “d”: 12 mm (0.47 in.) for glass upper
section
Position “d”: 16 mm (0.63 in.) for glass bottom
section
Position “d”: 32.5 mm (1.28 in.) for glass side
sections
(a)
(b)
I4RS0A950024-
I4RS0A950025-
1. Rear end door glass 2. Fastener