Suzuki SWIFT RS415 2017, Service Manual

Page: 554 / 1257

5A-14 Automatic Transmission:
Diagnostic Information and Procedures
A/T System Check
S4RS0A5104001
Refer to the following items for the details of each step.
Step 1. Customer Complaint Analysis
Record details of the problem such as failure, complaint and how it occurred as described by the customer.
For this purpose, use of such an inspection form will facilitate collecting information to the point required for proper
analysis and diagnosis.
Step Action Yes No
1 ) Customer complaint analysis
1) Perform customer complaint analysis.
Was customer complaint analysis performed?
Go to Step 2. Perform customer
complaint analysis.
2 ) DTC / freeze frame data check, record and clearance
1) Check for DTC.
Is there any DTC(s)?
Print DTC or write them
down and clear them by
referring to “DTC
Clearance: ”. Go to Step
3. Go to Step 4.
3 ) Visual inspection
1) Perform visual inspection.
Is there any faulty condition?
Repair or replace
malfunction part. Go to
Step 11. Go to Step 5.
4 ) Visual inspection
1) Perform visual inspection.
Is there any faulty condition?
Repair or replace
malfunction part. Go to
Step 11. Go to Step 8.
5 ) Trouble symptom confirmation
1) Confirm trouble symptom.
Is trouble symptom identified?
Go to Step 6. Go to Step 7.
6 ) Rechecking and record of DTC / freeze frame data
1) Recheck for DTC referring to “DTC Check: ”.
Is there any DTC(s)?
Go to Step 9. Go to Step 8.
7 ) Rechecking and record of DTC / freeze frame data
1) Recheck for DTC referring to “DTC Check: ”.
Is there any DTC(s)?
Go to Step 9. Go to Step 10.
8 ) A/T basic check and A/T symptom diagnosis
1) Check and repair according to “A/T Basic Check: ” and
“A/T Symptom Diagnosis: ”.
Are check and repair complete?
Go to Step 11. Check and repair
malfunction part(s). Go
to Step 11.
9 ) Troubleshooting for DTC
1) Check and repair according to applicable DTC flow.
Are check and repair complete?
Go to Step 11. Check and repair
malfunction part(s). Go
to Step 11.
10 ) Check for intermittent problems
1) Check for intermittent problems.
Is there any faulty condition?
Repair or replace
malfunction part(s). Go
to Step 11. Go to Step 11.
11 ) Final confirmation test
1) Clear DTC if any.
2) Perform final confirmation test.
Is there any problem symptom, DTC or abnormal condition?
Go to Step 6. End.