Suzuki SWIFT RS415 2017, Service Manual

Page: 123 / 1257

Engine General Information and Diagnosis: 1A-75
6 ECM voltage check
1) Turn OFF ignition switch.
2) Remove ECM from its bracket with ECM connectors
connected.
3) Check for proper connection of ECM connector at “C37-
24” terminal.
4) If OK, then turn ON ignition switch, measure voltage
between “C37-24” terminal of ECM connector and body
ground.
Is voltage about 4 – 6 V?
“LT GRN” wire is open
circuit.
If wire and connection
are OK, go to Step 7. Go to Step 7.
7 Wire circuit check
1) Disconnect connectors from ECM with ignition switch
turned OFF.
2) Turn ignition switch to ON position.
3) Measure voltage between “LT GRN” wire terminal of
ECT sensor connector and body ground.
Is voltage about 0 V?
Go to Step 8. “LT GRN” wire is
shorted to other circuit.
If wire is OK, substitute
a known-good ECM and
recheck.
8 Wire circuit check
1) Measure resistance between “C37-24” terminal of ECM
connector and “LT GRN” wire terminal of ECT sensor
connector with ignition switch turned OFF.
Is resistance below 5
:
?
Go to Step 9. “LT GRN” wire is high
resistance circuit.
9 Ground circuit check
1) Connect connectors to ECM.
2) Check for proper connection of ECT sensor connector at
“ORN” wire terminal.
3) Measure resistance between “ORN” wire terminal of
ECT sensor connector and vehicle body ground.
Is resistance below 5
:
?
Go to Step 11. Go to Step 10.
10 Ground circuit check
1) Remove ECM from its bracket with ECM connectors
connected.
2) Measure resistance between “C37-55” terminal of ECM
connector and vehicle body ground.
Is resistance below 5
:
?
“ORN” wire is open or
high resistance circuit.
Poor “C37-55”
connection. Faulty ECM ground
circuit.
If circuit is OK,
substitute a known-
good ECM and recheck.
11 ECT sensor check
1) Check ECT sensor according to “Engine Coolant
Temperature (ECT) Sensor Inspection: in Section 1C”.
Is it in good condition?
Substitute a known-
good ECM and recheck. Replace ECT sensor.
Step Action Yes No