Suzuki SWIFT RS415 2017, Service Manual

Page: 421 / 1257

Front Suspension: 2B-11
5) Install ball joint bolt (1) and nut (2) from the direction
as shown in figure.
6) Tighten new suspension arm ball joint nut (2) to
specified torque.
Tightening torque
Suspension arm ball joint nut (a): 60 N·m (6.0
kg-m, 43.5 lb-ft)
CAUTION:
Never reuse the removed suspension arm
ball joint nut.
7) Tighten strut bracket nuts (3) to specified torque.
Tightening torque
Strut bracket nut (b): 105 N·m (10.5 kg-m, 76.0
lb-ft)
8) Install ABS wheel speed sensor (1) (if equipped with
ABS).
Tightening torque
ABS wheel speed sensor mounting bolt (a): 25
N·m (2.5 kg-m, 18.0 lb-ft)
9) Connect tie-rod end (1) to steering knuckle (2),
tighten new nut (3) to specified torque.
Tightening torque
Tie-rod end nut (a): 45 N·m (4.5 kg-m, 32.5 lb-ft)
10) Install brake disk (2) and brake caliper (3).
11) Tighten caliper carrier bolt to specified torque.
Tightening torque
Caliper carrier bolt: 85 N·m (8.5 kg-m, 61.5 lb-ft)
12) Depress foot brake pedal and hold it there.
Tighten new drive shaft nut (1) to specified torque.
Tightening torque
Drive shaft nut (a): 175 N·m (17.5 kg-m, 126.5 lb-
ft)
CAUTION:
Never reuse drive shaft nut (1).
13) Caulk drive shaft nut (1) as shown.
CAUTION:
Be careful while caulking nut so that no crack
will occur in caulked part of nut. Cracked nut
must be replaced with new one.
14) Tightening wheel nuts to specified torque.
Tightening torque
Wheel nut: 85 N·m (8.5 kg-m, 61.5 lb-ft)
F: Forward
R: Rearward
I4RS0A220022-
1
(a)
I4RS0A220023-
1
2
3, (a)
I4RS0A220024-
I4RS0A220025-