Suzuki SWIFT RS415 2017, Service Manual

Page: 443 / 1257

Rear Suspension: 2C-13
Tightening torque
Rear spindle bolt (a): 75 N·m (7.5 kg-m, 54.0 lb-
ft)
2) Connect wheel speed sensor (1) and tighten wheel
speed sensor bolt (a) to specified torque.
Tightening torque
Wheel speed sensor bolt (a): 11 N·m (1.1 kg-m,
8.0 lb-ft)
3) Connect brake pipes to wheel cylinder (1) and
tighten brake pipe flare nut (a) to specified torque.
Tightening torque
Brake pipe flare nut (a): 16 N·m (1.6 kg-m, 11.5
lb-ft)
4) Install brake drum referring to Steps 2) – 7) of “Rear
Brake Drum Removal and Installation: in Section
4C”.
5) Fill reservoir with brake fluid and bleed brake
system. For bleeding operation, see “Air Bleeding of
Brake System: in Section 4A”.
6) Install wheel and tighten wheel nuts to specified
torque.
Tightening torque
Wheel nut (a): 85 N·m (8.5 kg-m, 61.5 lb-ft)
7) Upon completion of all jobs, depress brake pedal
with about 300 N (30 kg, 66 lbs) load three to five
times so as to obtain proper drum-to-shoe clearance.
Adjust parking brake cable. For adjustment, see
“Parking Brake Inspection and Adjustment: in
Section 4D”.
8) Check to ensure that brake drum is free from
dragging and proper braking is obtained.
9) Perform brake test (foot brake and parking brake).
10) Check each installed part for fluid leakage.
Spindle Inspection
S4RS0A2306045
• Inspect for cracks, deformation or damage.
Replace any defective part.
Rear Suspension Fasteners Inspection
S4RS0A2306025
Check each bolt and nut fastening suspension parts for
tightness. Tighten loose one, if any, to specified torque
referring to the figure in “Rear Suspension Component
Location: ”.
I4RS0A230025-
1 (a)
I4RS0A230041-
(a)
1
I4RS0A230027-
I2RH01220009-
I4RS0A230042-