Suzuki SWIFT RS415 2017, Service Manual

Page: 513 / 1257

ABS: 4E-10
NOTE:
If SUZUKI scan tool can not communicate
ABS hydraulic unit / control module, perform
“Serial Data Link Circuit Check: ”.
5) After completing the check, turn ignition switch off
and disconnect SUZUKI scan tool from DLC.
DTC Table
S4RS0A4504005
CAUTION:
Be sure to perform “ABS Check: ” before
starting diagnosis.
DTC Clearance
S4RS0A4504006
WARNING:
When performing a driving test, select a safe
place where there is neither any traffic nor
any traffic accident possibility and be very
careful during testing to avoid occurrence of
an accident.
After repair or replace malfunction part(s), clear all DTCs
by performing the following procedure or using SUZUKI
scan tool.
1) Connect SUZUKI scan tool to data link connector in
the same manner as when making this connection
for DTC check.
2) Turn ignition switch to ON position.
3) Erase DTC according to instructions displayed on
scan tool. Refer to scan tool operator’s manual for
further derails.
NOTE:
For DTC C 1021, C1022, C1025, C1026, C1031,
C1032, C1035, C1036 and C1061, confirm that
ABS warning lamp turns off after performing
Step 2 of “Test Driving” under “ABS Check:
”, and then clear the DTCs.
4) After completing the clearance, turn ignition switch
OFF and disconnect scan tool from data link
connector.
5) Perform “Driving Test” (Step 2 of “ABS Check: ”) and
“DTC Check: ” and confirm that NO DTC is displayed
on scan tool.
Scan Tool Data
S4RS0A4504007
The parameter data below are values measured with the
scan tool when the normally operating vehicle is under
the following conditions. When taking measurements for
comparison by using the scan tool, be sure to check that
the vehicle is under the following conditions.
• Apply parking brake and block wheels.
• Ignition switch ON.
• Turn OFF air conditioner (if equipped).
• Apply no load to power steering (if equipped). (Don’t
turn it)
• Turn OFF all electric loads (except ignition).
• No DTC.
• ABS is not operated. (Normal braking operation)
DTC (displayed on
SUZUKI scan tool)
Diagnostic Items
NO DTC Normal
) C1021 RF
Wheel speed sensor circuit
) C1025 LF
) C1031 RR
) C1035 LR
) C1022 RF
Wheel speed sensor circuit
or sensor ring ) C1026 LF
) C1032 RR
) C1036 LR
) C1041
RF
Inlet solenoid valve circuit
) C1042 Outlet solenoid valve circuit
) C1045
LF
Inlet solenoid valve circuit
) C1046 Outlet solenoid valve circuit
) C1051
RR
Inlet solenoid valve circuit
) C1052 Outlet solenoid valve circuit
) C1055
LR
Inlet solenoid valve circuit
) C1056 Outlet solenoid valve circuit
) C1057 Power source
) C1061
ABS pump motor and/or motor
driver circuit
) C1063
Solenoid valve power supply driver
circuit
) C1071 ABS control module
Scan Tool
Data
Standards Condition
Battery
Voltage
10.0 – 16.0 V —
Pump Motor
Driver
0.0 V —
RF Wheel
Speed
0 km/h, 0.0 MPH Vehicle stop
LF Wheel
Speed
0 km/h, 0.0 MPH Vehicle stop
RR Wheel
Speed
0 km/h, 0.0 MPH Vehicle stop
LR Wheel
Speed
0 km/h, 0.0 MPH Vehicle stop
Brake Switch
ON
Brake pedal
depressed
OFF Brake pedal released