Suzuki SWIFT RS415 2017, Service Manual

Page: 854 / 1257

7B-29 Air Conditioning System:
Compressor Drive Belt Removal and
Installation
S4RS0A7206036
Removal
1) Loosen tension pulley nut (1).
2) Loosen belt tension by loosening tension pulley
adjusting bolt (2).
3) Remove compressor drive belt (3).
Installation
Reverse removal procedure noting the following
instruction.
• Adjust belt tension referring to “Compressor Drive Belt
Inspection and Adjustment: ”.
Compressor Assembly Removal and
Installation
S4RS0A7206037
Removal
1) Run engine at idle speed with A/C ON for 10
minutes.
2) Stop the engine.
3) Disconnect negative (-) cable from battery.
4) Recover refrigerant from the A/C system with
recovery and recycling equipment referring to
“Recovery” in “Operation Procedure for Refrigerant
Charge: ”.
5) Remove compressor drive belt referring to
“Compressor Drive Belt Removal and Installation: ”.
6) Remove right side engine under cover.
7) Disconnect magnet clutch lead wire coupler (1).
8) Disconnect discharge hose (2) and suction hose (3)
from compressor (4).
NOTE:
Cap open fittings immediately to keep
moisture out of the system.
9) Remove compressor mounting bolts (1), and then
remove compressor (2) from its bracket.
Installation
Reverse removal procedure noting the following
instructions.
• If compressor is replaced, pour new compressor oil
referring to “Replenishing Compressor Oil” in
“Operation Procedure for Refrigerant Charge: ”.
• Evacuate and charge system referring to “Evacuation”
and “Charge” in “Operation Procedure for Refrigerant
Charge: ”.
• Adjust drive belt tension referring to “Compressor
Drive Belt Inspection and Adjustment: ”.
I4RS0A720034-
3
4
2
1
I4RS0A720035-
1
1
2
I4RS0A720036-