Suzuki SWIFT RS415 2017, Service Manual

Page: 718 / 1257

5B-9 Manual Transmission:
Manual Transaxle Unit Dismounting and
Remounting
S4RS0A5206033
Dismounting
1) Drain coolant.
2) Remove coolant reservoir with reservoir hose.
3) Remove battery and tray.
4) Remove air cleaner case and resonator.
5) Disconnect gear shift and gear select control cables
(1) from transaxle.
6) Disconnect back up lamp switch coupler and VSS
coupler and undo wiring harness clamps.
7) Remove ground cable from transaxle.
8) Remove clutch operating cylinder with fluid hose
from transaxle.
9) Remove water inlet No.2 pipe from transaxle.
10) Remove starting motor referring to “Starting Motor
Dismounting and Remounting: in Section 1I”.
11) Remove transaxle to engine bolts (1) of upper side.
12) Support engine using supporting device (1).
CAUTION:
Do not apply supporting device to projection
part A. If do so, it may be deformed.
13) Remove front drive shafts and center shaft referring
to “Front Drive Shaft Assembly Removal and
Installation: in Section 3A”.
14) Remove exhaust No.2 pipe referring to “Exhaust
Pipe and Muffler Removal and Installation: in
Section 1K”.
15) Remove clutch housing lower plate (1).
3. Engine rear mounting and bracket 10. Transaxle to engine nut : 85 N
˜
m (8.5 kg-m, 61.5 lb-ft)
4. Back up lamp switch connector 11. Ground cable : 55 N
˜
m (5.5 kg-m, 40.0 lb-ft)
5. VSS connector 12. Engine left mounting bracket : 23 N
˜
m (2.3 kg-m, 17.0 lb-ft)
6. Transaxle to engine bolt 13. Gear shift & select control cables : 11 N
˜
m (1.1 kg-m, 8.0 lb-ft)
1
I4RS0A520006-
1
1
I4RS0A520018-
1
A
I4RS0A520019-
1
I4RS0A520020-