Chapter 6: SX II Administration
75
4. change the port name, if needed.
5. Click OK. SX II attempts to communicate with the power strip. If
communication is successful, the port is configured as a power port.
Note: If the power strip is in not in support mode, a communication
failure occurs. Update the power strip to support mode from the
power strip application, then configure the port in SX II again..
6. Once a port is configured as power port, you can change outlet
names on the Port Edit page, as well.
Remove a Power Association
When disconnecting target servers and/or rack PDUs from the device, all
power associations should first be deleted. When a target has been
associated with a rack PDU and the target is removed from the device,
the power association remains. When this occurs, you are not able to
access the Port Configuration for that disconnected target server in
Device Settings so that the power association can be properly remove.
To remove a rack PDU association:
1. Select the appropriate rack PDU from the Power Strip Name drop-
down list.
2. For that rack PDU, select the appropriate outlet from the Outlet
Name drop-down list.
3. From the Outlet Name drop-down list, select None.
4. Click OK. That rack PDU/outlet association is removed and a
confirmation message is displayed.
To remove a rack PDU association if the rack PDU has been
removed from the target:
1. Click Device Settings > Port Configuration and then click on the
active target.
Summary of Contents for Dominion SX II
