Chapter 7: Connect a Rack PDU to SX II and Configure Power Control Options
235
3. Power on the PX2 (if it is not already). The command line interface
(CLI) interface appears.
PX appliance
SX II
Connecting the SX II to the PX2 FEATURE Port
In this configuration, the PX is managed from the SX II interface like any
other powerstrip. See Power Control.
Note that the appliances used in the diagram may not match your
specific models. However, the connections and ports used are the same
across models.
To connect the SX II to the Feature port on the PX:
1. Connect the red end of the CSCSPCS crossover Cat5 cable into the
Feature port on the PX.
2. Connect the yellow end of the CSCSPCS crossover Cat5 cable into
a port on the SX II.
3. Power on the PX (if it is not already).
Summary of Contents for Dominion SX II
