Chapter 6: SX II Administration
126
Configure SNMP Traps from the Remote Console
Simple Network Management Protocol (SNMP) is a protocol governing
network management and the monitoring of network devices and their
functions. SNMP provides the ability to send traps, or notifications, over
a network to gather information. This information is used to advise an
administrator when one or more conditions have been met.
SNMP-compliant devices, called agents, store data about themselves in
Management Information Bases (MIBs) and respond to the SNMP trap.
SNMP agents are configured in SX II on the Device Services page. See
Configure SNMP Agents
(see "
Configure SNMP Agents from the
Remote Console
" on page 124) for information on configuring SNMP
agents and
Viewing the SX II MIB
(on page 130) for information on
viewing the SX II MIB.
Tip: Use the Link to SNMP Agent Configuration link to quickly navigate to
the Devices Services page from the Event Management - Settings page.
The traps are configured on the Event Management - Settings page.
The following table lists the SX II SNMP traps:
Trap
Description
automaticScriptConfiguration
The device attempted an automatic configuration.
configBackup
The device configuration has been backed up.
configRestore
The device configuration has been restored.
deviceUpdateFailed
Device update has failed.
deviceUpgradeCompleted
The SX II has completed update via an RFP file.
deviceUpgradeStarted
The SX II has begun update via an RFP file.
ethernetFailover
When in failover mode, indicates a fail over has occurred.
factoryReset
The device has been reset to factory defaults.
firmwareFileDiscarded
Firmware file was discarded.
firmwareUpdateFailed
Firmware update failed.
firmwareValidationFailed
Firmware validation failed.
groupAdded
A group has been added to the SX II system.
groupDeleted
A group has been deleted from the system.
groupModified
A group has been modified.
ipConflictDetected
An IP Address conflict was detected.
ipConflictResolved
An IP Address conflict was resolved.
Summary of Contents for Dominion SX II
