Raritan Dominion SX II, Administrator'S Manual

Page: 229 / 272

Chapter 6: SX II Administration
222
In both cases above, port 1 will have an IP assigned as 10.0.13.200,
while port 2 will have 10.0.13.201, port 3 10.0.13.203, and so on.
The following example configures DPA port settings for SSH and Telnet
by TCP port.
admin > Config > Port > config port 1 ssh 7000 telnet 8000
DPA Telnet and SSH port changes are available immediately without
rebooting.
ssh -l sx_user -p 7000 10.0.13.13 or telnet -l sx_user
10.0.13.13 8000
admin@10.0.13.13's password:
Escape Sequence is: Control-
You are now master for the port.
After entering the password, you have direct access to port 1, using the
newly assigned TCP Ports(either ssh or telnet), specifically for port 1.
The following example configures DPA port settings for a group of ports
(make sure no TCP Ports have been assigned, and a free range of TCP
Ports are available for dpa TCP Port mode usage).
admin > Config > Port > config port 1-32 ssh 7000 telnet 8000
or
admin > Config > Port > config port * ssh 7000 telnet 8000
In both cases above, port 1 will have ssh port 7000 and telnet port 8000
assigned for direct port access, port 2 will have ssh port 7001 and telnet
port 8001, and so on.
To configure all ports using a block of contiguous port numbers, use the
<port *> command. If port_range is specified, a block of contiguous port
numbers are used. The given value of base_tcpport is used as starting
value. For individual port configuration, the <port number> command can
be used.
Configure the Local Port Using CLI
Note: These settings can also be configured from the Remote Console.
See
Configure Local Port Settings from the Remote Console (on
page 144).
Enter
admin > config > localport
to access the menu.
Con
Command Description Parameters
config
Configure local ports.

enable <true/false> - Standard Local Port, enable