Raritan Dominion SX II, Administrator'S Manual

Page: 226 / 272

Chapter 6: SX II Administration
219
Command Description Parameters
keywordadd Add a keyword to the port.

port <number | range | *> - Single port or
range of ports (1-n or 1,3,4 or * for all ports)

keyword <value> - When keyword is
detected on target, notification is sent.
keyworddelete
Delete an existing keyword from the
port.

port <number | range | *> - Single port or
range of ports (1-n or 1,3,4 or * for all ports)

keyword <value> - When keyword is
detected on target, notification is sent.
config port

port <number | range | *> - Single port or
range of ports (1-n or 1,3,4 or * for all ports)

name <port name> - Port name

bps <1200 | 1800 | 2400 | 4800 | 9600 |
19200 | 28800 | 38400 | 57600 | 115200 |
230400> - Port speed in bits-per-second

parity <none|even|odd> - Port parity type

flowcontrol <none|hw|sw> - Port flowcontrol
type hw = hardware flow control sw =X on/X
off)

eqtype <auto|dte|dce> - Equipment type
(auto=>AUTO Detection, dte=>Force DTE,
dce=>Force DCE)

Note: If the target has the ability to
autodetect either DTE or DCE, you must
select either Force DTE or Force DCE for
the port. SX II does not support
autodetection of both DCE and DTE on the
same port.

escapemode <none|control> - Use Ctrl-key
(escapemode=control) or single key
(escapemode=none) as escape sequence;
for example, Ctrl- => escapemode=control,
escapechar= escapechar char-Escape
character

Raritan recommends that you do not use or
Ctrl- as the Escape command. Either of
these may cause unintended commands,
such as opening a menu, instead of
invoking the Escape Command.

emulation <vt100 | vt220 | vt320 | ansi> -
Target Emulation type

sendbreak <duration> - Duration of the
sendbreak signal in milliseconds.

exitstring <cmd #delay; > - Execute exit
string when port session closes, for