Omron R88D-GT series, User Manual

Page: 395 / 510

6-14
6-4 Setting the Mode
6
Opera
tion
 Warning Display

Regeneration Load Ratio
• Displays the regeneration resistance load ratio as a percentage of the detection level for the
regeneration load.

Overload Load Ratio
• Displays the load ratio as a percentage of the rated load.

Inertia Ratio

Total Feedback Pulses and Total Command Pulses
• Displays the total number of pulses after the power supply is turned ON.
• The display on the front panel will overflow as shown in the following figure.
• The display on the Parameter Unit will be as shown in the following figure.
• Use the Shift key to switch the display between the upper and lower digits of the total number of
pulses.
• Hold down the Data key for 5 s or longer to reset the total pulses to 0.
: No w arning,
: Warning
Overload: 85% or more of the alarm level for
overload.
Battery w arning: Absolute encoder battery voltage dropped to 3.2 V or less
Fan lock: Abnormal cooling fan speed.
Over-regeneration: 85% or more of the alarm level for regeneration
overload.
The alarm level
w ill be 10% of the operating ratio of the regeneration
resistance if the Regeneration Resistor Selection (Pn6C) is set to 1.
Not used.
Displays the inertia ratio as a percentage.
2,147,483,647 pulses
−
2,147,483,647 pulses
−
2,147,483,647 pulses
Power ON
0
Forward Reverse
Upper digits Lower digits
Hk-k2k1kk4k7
4k8k3k6k4k7