Omron 8U0108-E1-01, User Manual

Page: 88 / 333

XtraDrive User Manual Chapter 5 : Parameter Settings and Functions
5-20
5.2.3. Using the Encoder Signal Output
Encoder output signals are divided inside the servo amplifier and can be
output externally. These signals can be used to form a position control
loop in the host controller.
XtraDrive
Frequency
div iding
circuit
Encoder
CN1
CN2
PG
Host
controller
These outputs
explained here
Phase A
Phase B
Phase C
The output circuit is for line-driver output. Connect each signal line
according to the following circuit diagram.
Note: Dividing means converting an input pulse train from the encoder mounted on the servomotor according
to the preset pulse density and outputting the converted pulse. The units are pulses per revolution (PPR).
I/O Signals
I/O signals are described below.
Output PAO CN1-33 Encoder Output Phase A Speed/Torque Control, Position Control
Output /PAO CN1-34 Encoder Output Phase /A Speed/Torque Control, Position Control
Output PBO CN1-35 Encoder Output Phase B Speed/Torque Control, Position Control
Output /PBO CN1-36 Encoder Output Phase /B Speed/Torque Control, Position Control
Output PCO CN1-19 Encoder Output Phase C Speed/Torque Control, Position Control
Output /PCO CN1-20 Encoder Output Phase /C Speed/Torque Control, Position Control
Divided encoder signals are outputs; therefore always connect these signal terminals
when a position loop is formed in the host controller for position control.
Set a dividing ratio using the following parameter: PG Dividing Ratio Pn201
The dividing ratio setting is not related to the gear ratio setting (Pn202 and 203) for
the servo amplifier electronic gear function during position control.