XtraDrive User Manual
Table of Contents/Preface
xv
CAUTION
•
Conduct trial operation on the servomotor alone with the motor shaft disconnected from
machine to avoid any unexpected accidents.
Not doing so may result in injury.
•
Before starting operation with a machine connected, change the settings to match the
parameters of the machine.
Starting operation without matching the proper settings may cause the machine to run out of
control or malfunction.
•
Before starting operation with a machine connected, make sure that an emergency stop
can be applied at any time.
Not doing so may result in injury.
•
Do not touch the heat sinks during operation.
Not doing so may result in burns due to high temperatures.
Maintenance and Inspection
WARNING
•
Do not remove the panel cover while the power is ON.
Doing so carries a risk of electric shock.
•
Do not touch terminals for five minutes after the power has been turned OFF.
Residual voltage may cause electric shock.
•
Never touch the inside of the servo amplifier.
Doing so may result in electric shock.
CAUTION
•
Do not disassemble the servomotor.
Doing so may result in electric shock or injury
•
Do not attempt to change wiring while the power is ON.
Doing so may result in electric shock or injury
Summary of Contents for 8U0108-E1-01
