Mindray ePM 10M, Operator'S Manual

Page: 221 / 364

24 - 3
NOTE
•
Auto recording on alarm happens only when Print on Alarm is set to Recorder. For more information,
see
27.4.6 The Other Tab
.
24.7 Clearing Recording Tasks
To clear recording tasks, follow this procedure:
1. Select the
Main Menu
quick key
→
from the
Report
column select
Record Setup
.
2. In the
Record Setup
menu, select
Clear All Record
. This clears all queued recording tasks and stops the
current recording.
24.8 Loading Paper
To load paper, follow this procedure:
1. Use the latch at the upper right of the recorder door to pull the door open.
2. Insert a new roll into the compartment as shown below. Feed the paper through and pull some paper out
from the top of the roller.
3. Close the recorder door.
CAUTION
•
Use only specified thermal paper. Otherwise, it may cause damage to the recorder’s printhead, the
recorder may be unable to print, or poor print quality may result.
•
Never pull the recorder paper with force when a recording is in process. Otherwise, it may cause
damage to the recorder.
•
Do not leave the recorder door open unless you reload paper or remove troubles.
24.9 Removing Paper Jam
If the recorder works incorrectly or produces unusual sounds, check if there is a paper jam first. If a paper jam is
detected, follow this procedure to remove it:
1. Open the recorder door.
2. Take out the paper and tear off the draped part.
3. Reload the paper and close the recorder door.