3 - 14
BeneVision N1 Patient Monitor Operator’s Manual
NOTE
•
If you enable Auto Daylight Saving Time, you cannot manually switch it on or off from the System
Time menu. For more information, see
3.8.2Setting the Date and Time.
3.8.4
Setting the Unit
To set the unit, follow this procedure:
1.
Select the
Main Menu
quick key
→
from the
System
column
select
Maintenance
→
input the required
password
→
select
.
2.
Set the
Unit
tab.
3.
Set measurement units for each parameter.
3.8.5
Adjusting the Screen Brightness
To adjust the screen brightness, follow this procedure:
1.
Access
Display
in either of the following ways:
◆
Select the
Screen Setup
quick key
→
select the
Display
tab.
◆
Select
the
Main Menu
quick key
→
from the
Display
column select
Display
.
2.
Set the
Brightness
. If
Brightness
is set to
Auto
, the monitor automatically adjust the screen brightness
according to the ambient light.
3.8.6
Adjusting the Key Volume
To adjust the key volume, follow this procedure:
1.
Select
the
Main Menu
quick key
→
from the
Display
column select
Display
.
2.
Set the
Key Volume
.
3.9
Starting Monitoring a Patient
After turning on your monitor, follow this procedure to monitor a patient:
1.
Admit the patient.
2.
Check patient settings. Make sure that alarm limits, patient category and paced status, and so on, are
appropriate for your patient. Change them if necessary.
3.
Perform desired measurements. For more information, see corresponding measurement chapters.
3.10
Stopping a Parameter Measurement
To stop monitoring a parameter, follow this procedure:
1.
Remove corresponding sensor from the patient.
2.
Disconnect the sensor from the patient cable.
3.
Disconnect the patient cable from the parameter connector.
4.
If you are using the disposable sensor, discard it.
3.11
General Operation
This section describes the operations that are generally used when monitoring a patient.
3.11.1
Switching On or Off a Parameter
You can manually switch on or off a parameter when its module is connected. To do so, follow this procedure:
1.
Access
Parameters On/Off
by any of the following ways:
