ADVANCED OPERATION - Section 5
MTS-1700 SERIES OPERATION AND REFERENCE MANUAL 5-37
CU A002 15A
MANTA TEST SYSTEMS
Select voltage to adjust/display voltage phase angle settings, or current to adjust/display current phase angle
settings.
If VOLTAGE is selected:
A display similar to the one on the following page will appear, showing the present settings for the
previously selected fault state:
Note that these numbers are settings--and not actual measured values--in contrast to the [VALUE
DISPLAY].
To change a particular setting, turn the [MODIFY] knob to move the cursor to the desired quantity. Press
[SELECT], and the cursor will move to the first digit of the phase value to be modified. An example is
shown below for VB.
Turn the [MODIFY] knob to the desired value, and then press [SELECT]. The cursor will move back to the
first letter of the quantity, as in the example displayed below:
Press [PREVIOUS] to return to the previous menu display.
If CURRENT is selected:
A display similar to the one below will appear, showing the present settings for the previously selected fault
state:
Note that these numbers are settings--and not actual measured values--in contrast to the [VALUE
DISPLAY].
To change a particular setting, turn the [MODIFY] knob to move the cursor to the desired quantity. Press
[SELECT], and the cursor will move to the first digit of the phase value to be modified. An example is
shown below for IC.
Turn the [MODIFY] knob to the desired value, and then press [SELECT]. The cursor will move back to the
first letter of the quantity, as in the example displayed below:
vA:000.0° vB:240.0°
vC:120.0°
iA:330.0° iB:240.0°
iC:163.5°
iA:330.0° iB:240.0°
iC:i20.0°
iA:330.0° iB:240.0°
iC:120.0°
vA:000.0° vB:240.0°
vC:120.0°
vA:000.0° VB:105.0°
vC:120.0°