ADVANCED OPERATION - Section 5
5-34 MTS-1700 SERIES OPERATION AND REFERENCE MANUAL
MANTA TEST SYSTEMS
CU A002 15A
The individual phase adjustment menu tree for I2-HARMONIC current mode is summarized in the figure
below:
FIGURE 5.15 INDIVIDUAL PHASE ADJUSTMENT MENU TREE
FOR I2-HARMONIC CURRENT MODE
5.12.2.1.3 I1&I2 current mode individual phase adjustment
In this current mode, after PREFAULT, FAULT or POSTFAULT is selected, a display similar to the one
below will appear, showing the present settings for that particular fault state.
Note that these numbers are settings--and not actual measured values--in contrast to the [VALUE
DISPLAY].
To change a particular setting, turn the [MODIFY] knob to move the cursor to the desired quantity. Press
[SELECT], and the cursor will move to the first digit of the phase value to be modified. An example is
shown below for I2.
Turn the [MODIFY] knob to the desired value, and then press [SELECT]. The cursor will move back to the
first letter of the quantity, as in the example displayed below:
Repeat this, as desired, for all phases, and for each of the prefault, fault and postfault states.
Prefault Fault Postfault
Normal Indiv_Volt Indiv_Current
VA VB VC I2
Enable Adjust
Individual_Adj_Mode Phs-seq Meas
VA VB VC I2
VA VB VC I2
VA:000.0° vB:240.0°
I1:000.0° I2:30.0°
VA:000.0° vB:240.0°
I1:000.0° I2:300.0°
vA:000.0° VB:240.0°
I1:000.0° I2:27.5°