Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1, Administration Manual

Page: 750 / 1026

•
High Availability (HA)—To configure a secondary Device Server, you need to specify
the IP Address and port, and Mapped IP Address (if applicable).
• E-mail Notification—You can configure an SMTP server to send you an e-mail notifying
you of various events on the Device Server.
•
Disk and Log Management—You can enable an alert and action when available disk
space reaches a specified minimum limit.
Refer to the Network and Security Manager Installation Guide for more information on
adding and configuring the Device Server.
Configuring the GUI Server
Table 79 on page 700 lists and describes device information that you can view through
the Server:
Table 79: GUI Server Table
Description Item
Name of the GUI Server. Name
Whether the current server is a GUI Server or GUI Server Cluster. Server Type
IP address of the GUI server. IP Address
IP address of the secondary server. IP Address of secondary
server.
You can configure the following parameters for the GUI Server:
•
Server Type—Select GUI Server or GUI Server Cluster. If you are installing the
management system with HA enabled, you need to configure the GUI Server as part
of an HA Cluster.
•
IP Address
•
HA parameters
• E-mail Notification—You can configure an SMTP server to send an e-mail to notify you
of events on the GUI Server. (See “Sending E-mail Notification of Downed Device” on
page 796 for details.)
NOTE: You must restart the GUI Server to apply any changes that you have
made.
Using Server Monitor
You can use the Server Monitor to view the status of the running GUI Server and Device
Server. The Server Monitor lists all GUI Servers and Device Servers in your management
system. For example, if you have installed a primary and secondary GUI Server in a high
Copyright © 2010, Juniper Networks, Inc. 700
Network and Security Manager Administration Guide