Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1, Administration Manual

Page: 746 / 1026

Table 74: RTO Counters Details (continued)
Description Item
The number of times that the RTO was placed to Set. Counter to Set
The number of times that the RTO was placed to Lost Peer. Counter to Lost Peer
The number of times that the RTO was placed to Group Detach. Counter to Group Detach
Monitoring IDP Clusters
If you have implemented IDP clusters for the purpose of redundancy, you can use the
IDP Cluster Monitor to get an at-a-glance status of your IDP sensors that are in clusters.
Table 75 on page 696 describes all of the information available from the IDP Cluster
Monitor:
Table 75: IDP Cluster Monitor
Description Item
Name of the cluster. Name
Status of the cluster (OK, Warning, or Fail). Status
Domain in NSM in which the source IDP cluster is managed. Domain
Viewing IDP Cluster Summary Information
Click IDP Cluster Monitor to view a summary of the top-level information on all IDP
clusters. From the IDP Cluster Summary, you can view the following details about a
specific cluster:
•
Key details describing the cluster (such as name, Status, Cluster ID)
• HA mode
Table 76 on page 696 describes all of the information that is available from the IDP Cluster
summary:
Table 76: IDP Cluster Summary
Description Item
Domain in NSM in which the source IDP cluster is managed. Domain
Name of the cluster. Name
Number uniquely identifying a cluster on a given Ethernet segment
(retrieved from all nodes) Cluster ID
Copyright © 2010, Juniper Networks, Inc. 696
Network and Security Manager Administration Guide