Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1, Administration Manual

Page: 267 / 1026

configuration, list entry g has been added directly (as shown by the lack of any data origin
icon), the template has been added, and then the list has been reordered.
Figure 56: Identifying Ordered List Entries that Do Not Match the Template
Order
In the device configuration in Figure 56 on page 217:
• The subsequence d, e, f is not highlighted because it is the longest common
subsequence between the device configuration and the template.
•
g is not highlighted because it does not come from the template.
• a and b have a continuous green highlight because they represent a common
subsequence, though not the longest.
•
c has a single-entry out-of-order mark because it is adjacent to neither of its neighbors
in the template.
NOTE: If multiple subsequences tie for the longest common subsequence,
then NSM picks either one but not both.
NSM recomputes the longest common subsequence each time the list is reordered and
makes changes to out-of-sequence highlighting accordingly.
Using the Template Operations Directive
The Template Operations directive allows you to add templates or remove templates
for multiple devices at one time, and to validate configurations after changes.
217 Copyright © 2010, Juniper Networks, Inc.
Chapter 5: Configuring Devices