Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1, Administration Manual

Page: 722 / 1026

tunnels. To remove a VPN tunnel from the list of Selected VPN tunnels, click to select
the VPN tunnel and click
Remove .
4.
Click OK .
Adjusting Data Depicted Graphically
1.
Right-click the Chart view and select Data , and either Delta or Absolute.
2.
Right-click the Chart view and select Data Type , and either Bytes In , Bytes Out ,
Packets In Packets Out , Utilization , Last Session Duration , Avg Latency , Availability .
3.
Click OK .
Viewing VPN-Specific Information
Click the VPN Monitor Table tab to view specific information about your VPN. From the
VPN Monitor Table, you can view the following details about a specific VPN:
• Key details describing the VPN (such as name, Policy ID, group and user associations,
VPN type).
•
Security Association (SA) information.
•
Traffic over the tunnel (such as bytes in/out, packets in/out, utilization).
Table 56 on page 672 describes all the information that is available from the VPN Monitor:
Table 56: VPN Monitor Table
Description Item
The name of the VPN. Name
Type of tunnel: Site-to-site or dial-up. VPN Type
The Security Association (SA) identification for the VPN at both ends
of the tunnel. SA Id
A unique identifier specified when the policy was configured. Policy Id--In/Out
The status of the VPN tunnel (up or down). Status
Whether or not the current SA has been established. SA Status
Time that the SA status last changed. Time-SA Status Change
Duration of last SA session. Last SA Session Duration
Group associated with the VPN. Group
User associated with the VPN. User
Distinguished Name (DN) of the VPN. DN Name
Copyright © 2010, Juniper Networks, Inc. 672
Network and Security Manager Administration Guide