Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1, Administration Manual

Page: 196 / 1026

or by checking the configuration status in Device Monitor. Ensure that the configuration
status for the device displays “Update Needed”, which indicates that the device has
connected but the management system has not updated the device configuration
yet.
2.
Update the device configuration by right-clicking the device and selecting Update
Device . The Job Information box displays the job type and status for the update; when
the job status displays successful completion, click Close .
After update is complete, the device status displays as “Managed”, indicating that the
device has connected and the management system has successfully updated the device
configuration.
Summarize Delta Configuration
NSM allows you to perform the command Summarize Delta Config on a device before
you update the device. You can cancel the Update Device directive as well as save the
Summarize Config output. The Update Device has the following two phases: Summarize
Delta Config and Update Device.
Users can change the default to combine these two phases so that the delta configuration
summary is automatically performed before the device is updated and the results are
used to update the device as an optimization. During this combined operation, both
results (Delta Config and Update Device) are available to you by selecting
View Device
Delta Config , if you have the appropriate administrator rights. Otherwise, you can still
update the device, but you cannot run Summarize Delta Config .
Example: User Successfully Selects and Updates Two Devices with Delta Option
1.
In the main navigation tree, select Device Manager > Devices .
2.
From the Device Manager launchpad, select Update Device to open the Update
Device(s) dialog box, listing all connected and managed devices.
3.
Select two devices you want to update.
4.
Select Run Summarize Delta Config (if deselected), and then click Apply Changes .
NSM displays the delta configuration results for both devices.
5.
Click Update .
6.
Close the Job Information window and select Job Manager from the main navigation
tree.
7.
Select Update Device to see the update device job results for both devices.
Example: User Selects Two Devices with Delta Option and One Device Fails
1.
In the main navigation tree, select Device Manager > Devices .
2.
From the Device Manager launchpad, select Update Device to open the Update
Device(s) dialog box, listing all connected and managed devices.
3.
Select two devices you want to update.
4.
Select Run Summarize Delta Config (if deselected), and then click Apply Changes .
Copyright © 2010, Juniper Networks, Inc. 146
Network and Security Manager Administration Guide