Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1, Administration Manual

Page: 599 / 1026

d.
Enter the routing instance. Enter the routing instance to which the IP addresses in
the address prefix field (see previous row) are bound to. This field is optional.
e.
Click
OK
.
A rule with the specified name gets created and is displayed in the Security Policy window.
Editing a Static NAT Rule/Rule Set
From the
Security Policy
window, select a row and then right-click on a column to edit
the values. You can perform the following actions:
•
Under the
Name
header:
• Add Rule
—Enables you to add rules to the rule set. Right-clicking opens the
New Rule
dialog box. Specify the name, destination address, address prefix, and routing
instance. Once you are satisfied with the values, click
OK
.
• Add Source
—Enables you to view and modify the source that you set previously.
• Under the Zone/RJ/Interface header > View/Modify Source —Enables you to view and
modify the source that you set previously.
•
Under the
Dest Addr
header >
Select Destination Address
—Edit the destination address.
•
Under the
Action
header>Select a row and then right-click to >
Edit Action
—Enables
you to edit the action set previously.
• Right-click on the
Install On
column to select a target device on which to install the
NAT policy.
• View the applicable shared objects in the drop-down list in the Shared Objects for Policy
section of the window. You can add, edit, delete and search for shared objects, which
are applicable to the specific NAT rulebase.
549 Copyright © 2010, Juniper Networks, Inc.
Chapter 11: Configuring Junos NAT Policies