Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1, Administration Manual

Page: 193 / 1026

7.
Specify Device User Name and password, or use the default administrator name and
passwords for the device.
8.
Check Restrict the use of the configlet to the current device to install the configlet
only on a device with the specified serial number.
9.
Click Next to display the decoded configlet. To see the encoded configlet, click the
Raw Configlet tab.
10.
Click Save to save the configlet (configlet files automatically use the format .cfg).
NOTE: You cannot edit a configlet file directly. To make changes to the
information in a configlet file, run the Activate Device wizard to regenerate
the configlet.
11.
Click Finish to close the Activate Device wizard.
12.
Send the configlet to the onsite administrator using email, CD, or another out-of-band
method.
The onsite administrator must complete the configlet installation process and the device
must successfully connect to the management system before you can update the device
with the modeled configuration.
For help with the configlet installation process, the onsite administrator can refer to the
Rapid Deployment Getting Started Guide . This guide provides step-by-step instructions
for connecting a security device to the network, preparing the device to use a configlet,
and installing and running the configlet.
You can track the connection status of the device to determine when the device connects.
Check the device configuration status by holding your mouse cursor over the device in
Device Manager, or by checking configuration status in Device Monitor.
• Before the device connects, the status displays “Waiting for 1st Connect”, indicating
that the management system has modeled and activated the device, but the device
has not connected.
• After the onsite administrator has installed the configlet, the device automatically
connects to the management system and the status displays “Update Needed”,
indicating that the device has connected but the management system has not yet
installed the modeled device configuration.
Installing the Configlet
The onsite administrator performs RD in two stages:
•
Preparing the security device
• Installing the configlet
The following sections detail each stage. For detailed, step-by-step instructions on
installing the configlet, see the
Rapid Deployment Getting Started Guide .
143 Copyright © 2010, Juniper Networks, Inc.
Chapter 4: Adding Devices