Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1, Administration Manual

Page: 181 / 1026

Requirements
To model a device, you must know the device type and OS name and version that is
running on the device.
To activate a device:
•
You must have the device connection information and device administrator name and
password.
NOTE: All passwords handled by NSM are case-sensitive.
•
The device must be staged; that is, it must be physically connected to your network
and able to access network resources.
• The device must have at least one interface that has an IP address. Devices that use
dynamically assigned IP address must also support NACN.
Modeling a Device
To add and model a device:
1.
From the domain menu, select the domain in which you want to model the device.
2.
In Device Manager, select Devices .
3.
Click the Add icon, and then select Device . The device wizard appears.
4.
Select Model Device , and then click Next .
5.
In the Specify Name, Color, OS Name, Version, and Platform screen, enter the following
information:
•
Enter a name and select a color to represent the device in the UI.
• In the OS Name list, select the device family that the modeled device belongs to.
•
For Junos devices, select the Junos OS type:
• To model a J Series or SRX Series device, or an SRX virtual chassis, select J/SRX
Series from the list.
•
To model an EX Series device or virtual chassis, select EX Series .
• To model an M Series or MX Series device, select M/MX Series .
•
In the platform list, select the device platform name.
• In the OS version list, select the version of the operating system or firmware that
runs on the device.
6.
For EX Series switches, check Virtual Chassis if you wish to model a virtual chassis
(an array of EX4200 series switches). For an SRX virtual chassis check Virtual Chassis
if you wish to model an SRX virtual chassis.
131 Copyright © 2010, Juniper Networks, Inc.
Chapter 4: Adding Devices