Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1, Administration Manual

Page: 194 / 1026

Preparing the Device
Before you install the configlet, you must prepare the security device:
1.
Connect the device to your network. For details on connecting the device, see the
user’s guide that came with your security device.
2.
Connect a standalone computer, such as a laptop, to the device's eth1 port.
• To connect directly to the device, use a crossover cable.
•
To connect to the device over a hub or switch, use a straight-through cable.
If your device has auto-sensing ports, you can use any type of Ethernet cable to connect
to the device.
3.
Change the IP address of the standalone computer to
192.168.1.2
and the default
gateway to
192.168.1.1
. To change an IP address, see your computer’s operating system
documentation.
4.
Ensure that the device is using the factory default settings.
• RD works with the factory default settings of all security devices running ScreenOS
5.x or a later release. If the device does not use the factory default settings, you
cannot use RD (the WebUI cannot load the configlet).
• To restore the factory defaults on the firewall device, see the user’s guide that came
with your security device.
5.
Ensure that the Status LED on firewall device displays green.
Installing the Configlet
NOTE: During the configlet installation process, you cannot edit the device
configuration.
To install the configlet:
1.
Save the configlet on the standalone computer that you connected to the security
device.
2.
In a Web browser, enter the IP address of the trust interface on the security device as
192.168.1.1
. The Rapid Deployment Wizard appears.
3.
Select Load configlet file and browse to the location of the saved configlet file. Click
Next .
The RD Wizard opens the configlet, authenticates the integrity of the configlet, and
decrypts the configlet. If the configlet is valid, the RD Wizard uses the configlet
information to prepare the security device for NSM management.
4.
If prompted, enter the configlet password and click Next . The configlet password is
given to you by the NSM administrator who sent you the configlet file. Click Next .
Copyright © 2010, Juniper Networks, Inc. 144
Network and Security Manager Administration Guide