Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1, Administration Manual

Page: 469 / 1026

•
Click
OK
.
3.
Click OK . Proxy ARP is now configured.
Editing a Source NAT Object
To edit a source NAT object:
1.
Select Object Manager > Junos NAT Objects > Source NAT . The Source NAT dialog box
appears.
2.
Select a source NAT object to edit.
3.
Select the Edit icon at the top of the screen. The
JunosSource NAT
dialog box appears.
4.
Select the device to edit.
5.
Select the Edit icon. The Junos Source NAT dialog box appears.
6.
Edit the values of the source NAT object.
7.
Click OK .
Deleting a Source NAT Object
To delete a source NAT object:
1.
Select Object Manager > Junos NAT Objects > Source NAT . The Source NAT dialog box
appears.
2.
Select a source NAT object to delete.
3.
Select the Delete icon (
-
) at the top of the screen.
The
Delete JunosSource NAT Source NAT-object name
dialog box appears.
4.
Click
Next
.
If you have referenced this object, then all referenced areas are displayed as links in
this dialog box. Click on a link to navigate to the area where this object is referenced.
You can proceed with or cancel the deletion. If the deletion is successful, the following
message appears in the dialog box:
Deleted Source NAT-object name
.
5.
Click
Finish
.
Configuring Destination NAT Objects
A destination NAT object consists of a user-defined address pool and is used during
destination address translation. You can use this object while configuring a rule so that
when the rule is matched, the destination IP address of the packet is translated to an IP
address from this pool.
You can add, edit, delete, and search for a destination NAT object from Object Manager .
For more information, see the following sections:
• Adding a Destination NAT Object on page 420
• Editing a Destination NAT Object on page 421
•
Deleting a Destination NAT Object on page 422
419 Copyright © 2010, Juniper Networks, Inc.
Chapter 8: Configuring Objects