Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1, Administration Manual

Page: 241 / 1026

NOTE: When you open a device for viewing or editing, the NSM UI loads the
entire device configuration into memory to enhance UI performance while
configuring the device. When you close a device to which you made changes,
the UI unloads some of the device configuration from the client memory.
Although this memory optimization occurs quickly, you might see the following
message appear: “Optimizing client memory usage for device”.
For Secure Access, Infranet Controller, and Junos devices, NSM displays two tabs of
information:
•
The Device Info tab
•
The Configuration tab
Figure 40 on page 191 shows an example.
Figure 40: Device Info and Configuration Tabs
The Device Info tab contains information maintained in NSM. This information can neither
be imported from the device, nor is it ever pushed to the device by an Update Device
directive. It contains the following information:
•
Info—Basic device information such as name, OS version, and IP address.
•
Startup—Startup information such as the one-time password, which is required for
modeled devices and imported devices that use a dynamic IP address. The one-time
password is used to authenticate the first connection between the device and NSM.
•
Templates—All templates available to the device family to which the device belongs.
See “Using Device Templates” on page 198 for details.
• Device Admin—Polling interval for alarm statistics.
191 Copyright © 2010, Juniper Networks, Inc.
Chapter 5: Configuring Devices