Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1, Administration Manual

Page: 784 / 1026

Reference Point Pane
Use the Reference Point pane to view a list of reference objects. Next to the graph, a list
of the possible initial objects appears:
•
Address objects—For host/network selection. The selected host appears in a Peer
Graph, with selected network in a Outbound Service graph.
• Service objects—Displayed in an Outbound IP graph.
•
IDP Attacks—Displayed in an Attack-Network graph.
•
Context objects—Displayed in a Value graph.
Double-click on an object to set it as a point of reference in the main graph.
Log Viewer
Use the Logs tab in the viewer that appears below the main graph to view all logs related
to the point of reference that you have selected.
Reports Viewer
Use the Reports tab to generate and view one of the following reports in Security Explorer:
•
Top Alarms
•
Top Traffic Alarms
• Top Traffic Logs
• Top IDP/DI Attacks
•
Top Screen Attacks
•
Top Destination IPs
• Attacks over time
• Attacks by severity
•
Attacks by flag
•
Critical severity attacks
• High severity attacks
Use the Source/Destination Address pull-down menu to view these reports based on
either the Source IP or Destination IP.
Use the time duration pull-down menu to view data in these reports during a specific
time frame. You can select to view data from the last 24, 12, 8, 4, 2, 1 hours.
Using Security Explorer
You can launch the Security Explorer in any of the following ways:
• From the Security Monitor tree node, select Security Explorer.
Copyright © 2010, Juniper Networks, Inc. 734
Network and Security Manager Administration Guide