Iwatsu CS-3000 Series, Instruction Manual

Page: 49 / 234

Capter 3
Function Setting and Basic Operation
Curve Tracer CS-3000 Series Instruction Manual 3-3
3.2 Setting up this instrument
Set up this instrument in the location and environment which satisfy conditions below:
☆
Flat and horizontal surface
Set up this instrument on the stable surface while keeping it horizontal in all directions. If not, it
may fall or come down, resulting in injury to your body or damage to this instrument.
If installing it on the rack, the rack should be selected in accordance with the size of this
instrument: CS-3100: width: 424 mm, depth: 555 mm, and height: 220 mm; CS-3200/3300:
width: 424 mm, depth: 555 mm, and height: 354 mm (excluding attachment and projection).
☆
Well ventilated location
There are the air hole on each side of this instrument and (CS-3200/CS-3300 have another air
hole at the lower part on the front) and the exhaust hole on the rear. To prevent the
temperature in this instrument from increasing, there should be sufficient spaces around it and
the air holes and the exhaust hole should not be obstructed. Recommended spaces are sized
100mm each for left side, right side and rear of this instrument.
∗ CS-3200/CS-3300 has the filter attached to the air hole on the front panel. For cleaning the filter, see
Section 5.1 "Cleaning dust filter" of Chapter 5.
☆
Specification ensured temperature and humidity, operation ensured temperature and
humidity
Specification ensured temperature range:
+ 10 ° C to + 35 ° C (without dew condensation)
Operation ensured temperature and humidity range:
0 ° C to + 40 ° C,
5 % to 80 % RH (at 30 ° C) and no dew condensation allowed
Upper limit:
55 % RH (at 40 ° C) and no dew condensation allowed
Caution!
When transferring to an environment with different temperature and humidity, sudden temperature
change may cause dew condensation. In such a case, this instrument should be inured to the ambient
temperature before using it; ambient temperature gradually changes.