INVT GD300-004G-4, Operation Manual

Page: 82 / 312

Goodrive300 inverters Function codes
81
Functi
on
code
Name Detailed instruction of parameters
Default
value
Modif
y
P05.08
S8
terminals
function
selection
0
◎
P05.09
HDI
terminal
function
selection
28:Counter reset
29:Torque control disabling
30:ACC/DEC disabling
31:Counter trigging
32:Length reset
33:Cancel the frequency change setting
temporarily
34:DC brake
35:Shift the motor 1 into motor 2
36:Shift the command to the keypad
37:Shift the command to the terminals
38:Shift the command to the communication
39:Pre-magnetized command
40:Comsumption power clear
41: Comsumption power holding
42~63:Reserved
0
◎
P05.10
Polarity
selection of
the input
terminals
The function code is used to set the polarity of the
input terminals.
Set the bit to 0, the input terminal is anode.
Set the bit to 1, the input terminal is cathode.
BIT0 BIT2 BIT3 BIT4 BIT5
S1 S2 S3 S4 S5
BIT6 BIT7 BIT8 BIT9
S6 S7 S8 HDI
The setting range:0x000~0x1FF
0x000
○
P05.11
ON-OFF
filter time
Set the sample filter time of S1~S8 and HDI
terminals. If the interference is strong, increase the
parameter to avoid the disoperation.
0.000~1.000s
0.010s
○
P05.12
Virtual
terminals
setting
Enable the input function of virtual terminals at the
communication mode.
0:Virtual terminals is invalid
1:MODBUS communication virtual terminals are
0
◎