For areas where devices using dynamic IP addresses instead of
static ones, you can add access control device connected via
EHome protocol by specifying the EHome account.
Before You Start
Set the network center parameter first. For details, refer to Set
Steps
Note
For the devices added by EHome don't support uploading events
with captured pictures to the client.
1. Enter Device Management module.
2. Optional: Click on the right of Device Management and
select Device.
The added devices are displayed in the list.
3. Click Add to open the Add window.
4. Select EHome as the adding mode.
5. Enter the required information.
Device Account
Enter the account name registered on EHome protocol.
EHome Key
Enter the EHome key if you have set it when configuring
network center parameter for the device.
Note
This function should be supported by the device.
6. Optional: Check Synchronize Time to synchronize the device
time with the PC running the client after adding the device to
the client.
7. Optional: Check Import to Group to create a group by the
device name.
8. Finish adding the device.
-
Click Add to add the device and back to the device list page.
-
Click Add and New to save the settings and continue to add
other device.
9. Optional: Click on Operation column to view device status.
Import Devices in a Batch
The devices can be added to the software in a batch by entering
the device information in the pre-defined CSV file.
Steps
1. Enter the Device Management page
2. Click Add to open the adding device window.
3. Select Batch Import as the adding mode.
4. Click Export Template and then save the pre-defined template
(CSV file) on your PC.
5. Open the exported template file and enter the required
information of the devices to be added on the corresponding
column.
Adding Mode
51
