Steps
Note
The parameters configured here will be set as default for the
newly added time period. It will not affect the existed one(s).
1. Enter Time & Attendance module.
2. Click Attendance Settings → General Rule .
3. Set the day as week beginning and the date as month
beginning.
4. Select the day(s) as weekend.
5. Set absence parameters.
6. Click Save.
Configure Overtime Parameters
You can configure the overtime parameters for workday and
weekend, including overtime level, work hour rate, attendance
status for overtime, etc.
Steps
1. Enter Time & Attendance module.
2. Click Attendance Settings → Overtime .
3. Set required information.
Overtime Level for Workday
When you work for certain period after end-work time on
workday, you will reach different overtime level: overtime
level 1, overtime level 2 and overtime level 3 . You can set
different work hour rate for three overtime levels,
respectively.
Work Hour Rate
Set corresponding work hour rates for three overtime levels,
which can be generally used to calculate total work hours.
Overtime Rule for Weekend
You can enable overtime rule for weekend and set
calculation mode.
4. Click Save.
Configure Attendance Check Point
You can set the card reader(s) of the access point as the
attendance check point, so that the authentication on the card
readers will be recorded for attendance .
Before You Start
You should add access control device before configuring
attendance check point. For details, refer to Add Device.
Steps
Note
By default, all card readers of the added access control devices
are set as attendance checkpoint.
1. Enter the Time & Attendance module.
2. Click Attendance Settings → Attendance Check Point to enter
the Attendance Check Point Settings page.
101
