Note
If you set Communication Direction as Sending, you are
required to set the Wiegand Mode as Wiegand 26 or Wiegand
34.
6. Check Enable Wiegand to enable the Wiegand function.
7. Click Save.
• The configured parameters will be applied to the device
automatically.
• After changing the communication direction, the device will
reboot automatically.
Set Attendance Status
You can set the attendance mode on the device via the client. You
can also set the attendance parameters as check in, check out,
break out, break in, overtime in, and overtime out on the device
according to your actual needs.
Note
This function should be supported by the device.
Disable Attendance Mode
Disable the attendance mode and the system will not display the
attendance status on the device initial page.
Before You Start
Add at least one person, and set the person's authentication
mode. For details, see Person Management.
Steps
1. Click Access Control → Advanced Function → More
Parameters to enter the More Parameters page.
2. Select a device from the left panel.
3. Click Attendance Status.
4. Set the attendance mode as Disable.
5. Click Save.
Result
The attendance status function is disabled, and you will not view
or configure the attendance status on the device initial page.
Set Auto Attendance
Set the attendance mode as auto, and you can set the attendance
status and its available time duration. The system will auto
change the attendance status according to the configured
parameters.
Before You Start
Add at least one person, and set the person's authentication
mode. For details, see Person Management.
Steps
1. Click Access Control → Advanced Function → More
Parameters to enter the More Parameters page.
2. Select a device from the left panel.
3. Click Attendance Status.
4. Set the attendance mode as Auto.
5. Make sure Attendance Status Required is enabled.
87
