Note
The target door and the source door cannot be the same
one.
Audio Play
The audio prompt will be triggered. And the select audio
index related audio content will be played according to the
configured play mode.
7. Click Save.
8. Optional: After adding the device linkage, you can do one or
more of the followings:
Edit Linkage
Settings
Select the configured linkage settings in the
device list and you can edit its event source
parameters, including event source and
linkage target.
Delete
Linkage
Settings
Select the configured linkage settings in the
device list and click Delete to delete it.
7.6.3 Configure Device Actions for Card Swiping
You enable access control device's linkage actions (such as
disarming a zone and triggering audio prompt) for the swiping of
a specific card, In this way, you can monitor the card holder's
behaviors and whereabouts.
Steps
Note
It should be supported by the device.
1. Click Access Control → Linkage Configuration .
2. Select the access control device from the list on the left.
3. Click Add to add a new linkage.
4. Select Card Linkage as the event source.
5. Enter the card number or select the card from the drop-down
list.
6. Select the card reader where the card swipes.
7. In the Linkage Target area, set the property target to enable
this action.
Buzzer on Controller
The audible warning of access control device will be
triggered.
Buzzer on Reader
The audible warning of card reader will be triggered.
Capture
An event-related picture will be captured when the selected
event happens.
Recording
An event-related picture will be captured when the selected
event happens.
92
